Mounting A Shelf On Lathe And Plaster Walls

I asked our gc if he could mark the studs on the wall so that when i decided on a rack i could mount it myself.

Mounting a shelf on lathe and plaster walls. Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail. For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done. Plaster is a hard durable material but it s also resistant to penetration. Seat the round flange flush with the wall surface by tapping the screwhead.

Ch hanson 0304 magnetic stud finder. Amazon affiliate http amzn to 1iofrse ryobi corded drill with c. Hanging things on lath and plaster walls is a tricky business. Make sure you leave half an inch out of the wall so you have space to hang your artwork.

Next make a little shelf of the wide painters tape with the sticky side up to catch the plaster that will come out of the wall when you drill. Screw the bracket into place. Hanging things on plaster walls is easy if you have a drill and screws. Position the bracket on the wall and fasten it to.

Drill a pilot hole through the plaster and into the stud at each mark using a drill bit that is slightly smaller than the bracket mounting screws. Take care not to overtighten. You ll know this is happening if the anchor flange starts to depress the surface of the plaster or drywall. Put the hole over the x that you ve marked on the wall.

Though there are several methods of locating studs or supports behind the wall the most reliable is using a magnetic stud finder. We just finished a small kitchen remodel and i was going to put up a metal bookshelf potrack. If it is being mounted to the plaster wall use a molly or toggle bolt. Mounting a shelf on lathe and plaster walls.

If it is being mounted to a stud use wood screws. Here are links to the product we used in this video. When working with molly or toggle bolts screw them in until the back part has expanded completely and is securely holding the bracket to the plaster wall. Driving anything much larger than a pin nail into.

Turn the screw to mushroom the slotted sleeve against the back wall surface.